Protectowire 2000 FireSystem Especificaciones descargar pdf (Pagina 51)

~48 ~

1ST

LAST

ELR

4.7K

1/2W

1ST

LAST

1ST

ALARM ENABLE INPUT #1

ALARM ENABLE INPUT #2

ALARM ENABLE INPUT #4

ALARM ENABLE INPUT #3

AUX. ALARM RELAY DRIVE

SPARE

AUX. ALARM RELAY DRIVE

ALARM ENABLE INPUT #3

ALARM ENABLE INPUT #4

ALARM ENABLE INPUT #2

ALARM ENABLE INPUT #1

CLASS B CONFIGURATION

CLASS A CONFIGURATION

TE1

TE2

-) RETURN

-) OUT

(+) OUT

+) RETURN

TE2

TE1

FUSE

1.5 AMP

3AG

AE-91

SILENCE SWITCH

TEST SWITCH

ALARM

SILENCED

SHORT

OPEN

%@D9?>L+M<1B=H@1>45B1B4

)(&*%$

The AE-91 Alarm Expander Card provides one alarm notification appliance circuit which may be wired in a Class A or Class B

configuration (NFPA styles X and Z or W and Y). The module plugs into an expander board (EB-91A) expansion slot and can be

factory programmed for general alarm activation or for selective activation by up to (4) individual detection zones.

%&(*%$

A reverse polarity supervisory current monitors the field loop integrity reporting any short or open in the circuit to the control

panel. When a fault condition occurs the respective LED (yellow) illuminates in conjunction with the system trouble LED and the

system trouble buzzer pulses. Once an alarm input is received, general alarm or individual pre-programmed zones, the circuit

polarity reverses and 24V FWR is supplied to the field output terminals. The Alarm LED illuminates indicating activation. By

pressing the “Silence” button the alarm notification appliance circuit may be silenced. Once the circuit is silenced, pressing the

system reset button “Sys. Rst.” will reset the circuit. If the circuit is not silenced, pressing the “Sys. Rst.” button will reset the con-

trol panel but the Alarm Expander will remain in an alarm state until its “Silence” button is pressed. When wired as a Class A cir-

cuit, all devices will be supplied power in the event of a single open condition in the field wiring. When wired as a Class B circuit,

only the devices before the open condition will be supplied with power. Devices beyond the open condition G9<<>?D operate. This

module is equipped with an “Alarm Test” button that will simulate an alarm output being received by the module.

H@1>45B?1B4

95<4*5B=9>1<C

<1B=H@1>45B1B4



9C@<1I&1>5<



<1B=,?<D175 24 V Full wave rectified (FWR)

<1B=EBB5>D 1 amp per circuit Maximum

)E@5BF9C?BIEBB5>D 0.002 amp maximum

<1B=(5<1I! P&B R10-E1-X4-V185

EC5 1.5 amp (3 AG)

Maximum (2) conductor copper feed cable resistance may not exceed

1 ohm (Reference DS-9066)

*Circuit current rating may be limited (reduced) depending on the power

requirements of the system. Reference the Installation Wiring Diagram

for the specific rating of each system

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 62 63

Comentarios a estos manuales

Sin comentarios

Protectowire 2000 FireSystem Especificaciones Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Protectowire 2000 FireSystem